Dakota Sewalong - Full Bust Adjustment

Following on from Alana's comprehensive grading post, she's now generously sharing a post solely dedicated to the Full Bust Adjustment (FBA). Again, I'm sure you'll also be able to take these principles and apply them to other projects in the future!


This one is for those who need a little more room at the bust only. Generally if you are larger than a B-cup or if your muslin shows pulling at the bust, a full bust adjustment could be an option.

Here's how I made my FBA on the Dakota pattern.

First choose your cutting size and FBA amount by taking your upper-bust measurement - see this post if you haven't done this before.

Trace off the bodice front, grab a ruler and start by marking the three lines you need to make the adjustment.




Stick the pattern piece to a flat surface at the shoulder so it doesn't wiggle around then make the first cut.


Leave a little hinge at the seam line - this ensures we don't make the armhole bigger and the sleeve will still fit in.



At this point you could fill in the gaps and have a bodice with two bust darts - one going to the side seam and one going to the waist seem but if you want to keep the original design lines you can close that side dart back up which is what I ended up doing.


At the same time I made a little adjustment to help stop the gaping you get when you have a low cut or wrap bodice and a large bust. I wasn't sure whether to include it because it's not really a technical thing - just something I've figured works for me through trial and error. I just took a small amount of length out of the collar edge - about 1-2cm. If you've ever tightened the ties on a wrap top - it has the same effect.


Smooth out the collar edge and re-draw the roll line.

To mark your new dart find the centre point by measuring between the two end points of the old one. Join this point with each of the legs.


Note: If your FBA is quite large the uptake of this dart can be a little overwhelming, e.g., mine almost reached the side seam once stitched and pressed. I definitely recommend making a muslin and using the markings as a guide for pin-fitting the dart. I found I got a much better shape like this :)


Don't forget to trace off a new collar facing too!

Alana, Rachel and I can't thank you enough for your invaluable contribution to the Dakota Sewalong...you're an absolute gem! Friends, if you've yet to check out Lazy Stitching, you're missing a treat! 

7 comments:

  1. I'm not sewing the Dakota but this was the BEST illustration of an FBA that I've seen. Thank you!

    ReplyDelete
    Replies
    1. Thanks for saying so, we think Alana's amazing too!

      Delete
  2. Thank you soooo much for this! I always have the problem of my bust being larger than my cutting size... That will be over now! :D

    ReplyDelete
  3. Thanks for posting this!! Just a quick mention that the vertical dart can also be split into two, if you want to reduce the size - check out this article from colette patterns!! http://www.coletterie.com/sewalongs/fba-bonus-splitting-the-dart

    ReplyDelete
  4. I am so grateful as I have been trying to improve on a pattern for one of the bridesmaids dresses. I am making it up in muslin and will be trying it on her in a couple of weeks. I am sure this will fit, Your diagrams were so helpful and very well explained. It made it just so much easier, thnanks a million

    ReplyDelete